[Free] 2018(Mar) EnsurePass Passguide VMware VCP510PSE Dumps with VCE and PDF Download 121-130

Ensurepass.com : Ensure you pass the IT Exams 2018 Mar VMware Official New Released VCP510PSE
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/VCP510PSE.html

VMware Certified Professional on vSphere 5

Question No: 121 – (Topic 3)

Which options would reduce the load on the VMkernel when connecting to an iSCSI array? (Choose two.)

  1. Use an independent hardware iSCSI adapter

  2. Use a Converged Network Adapter

  3. Enable the software iSCSI adapter

  4. Use a dependent hardware iSCSI adapter

Answer: A,D Explanation:

Since independent hardware iSCSI adapter doesn’t need a VMkernel port, and it uses all its networking and management interfaces all by itself, it will significantly reduce the load on VMkernel. Similarly, dependent iSCSI adapter use very little resources and hence can reduce the load off VMkernel.

Question No: 122 – (Topic 3)

ACME Tools has a vSphere 5.x deployment with an older iSCSI storage array. The administrator isconsidering adding an additional array, which will include support for the vStorage APIs for Array Integration (VAAI).

Which two tasks would be completed in a reduced period of time if the new array was added? (Choose two.)

  1. creating VMFS datastoreson the new array

  2. creating fault tolerant virtual machines on the new array

  3. migrating virtual machines using Storage vMotion between the arrays

  4. writes to thin provisioned virtual disks on the new array

Answer: B,D

Reference:http://searchvirtualstorage.techtarget.com/definition/vStorage-APIs-for-Array- Integration-VAAI

Question No: 123 – (Topic 3)

A vSphere 5.x environmenthas an ESXi 5.x host configured to boot from a hardware independent iSCSI adapter.

What is the expected outcome if the administrator attempts to disable the iSCSI HBA in the vSphere client?

  1. The adapter will be disabled, but is re-enabled the next time the host boots up.

  2. The adapter will be disabled and the host will not boot the next time the host boots up.

  3. A hardware independent iSCSI adapter cannot be disabled from the vSphere Client.

  4. The adapter will be enabled, but the host will boot into troubleshooting mode the next time the host boots up.

Answer: C Reference:https://www.aglt2.org/wiki/pub/AGLT2/SetupMD3600i/vsp_41_iscsi_san_cfg.pdf (page 31 onwards)

Question No: 124 – (Topic 3)

How does a hardware FCoE Adapter appear to an ESXi host?

  1. As an uplink adapter attached to a vSphere Distributed Switch.

  2. As a hardware FCoE Adapter.

  3. As an enabled FCoE software initiator.

  4. As a Fibre ChannelAdapter.

Answer: D

Reference:http://pubs.vmware.com/vsphere- 50/index.jsp?topic=/com.vmware.vsphere.storage.doc_50/GUID-A9503ED6-2622- 4278-890E-B869C3971A9F.html

Question No: 125 – (Topic 3)

What two statements are true about Fibre Channel zoning? (Choose two.)

  1. Zones define paths to a Fibre Channel array

  2. Zones control access to LUNs on a Fibre Channel storage array

  3. Zones can be soft or hard

  4. Zones can be configured on an array or ESXi host

Answer: A,C

Reference:http://pubs.vmware.com/vsphere- 51/index.jsp?topic=/com.vmware.vsphere.storage.doc/GUID-E7818A5D-6BD7- 4F51-B4BA-EFBF2D3A8357.html

Question No: 126 – (Topic 3)

What are two requirements when configuring a Fibre Channel SAN with an ESXi 5.x cluster? (Choose two.)

  1. RDMs must be zoned and masked to each ESXi 5 host in the cluster

  2. A FCP HBA or hardware supporting FCoE must be installed in the hosts

  3. Each LUN should contain only one NFS datastore.

  4. Each LUN must present a unique LUN ID to each ESXi hosts.

Answer: A,B

Explanation: A: correct because yes, you have to Zone and mask to allow only the Hosts in that you want in.

Zoning has the followingeffects:

  • Reduces the number of targets and LUNs presented to a host.

  • Controls and isolates paths in a fabric.

  • Can prevent non-ESXi systems from accessing a particular storage system, and from possibly destroying

    VMFS data.

  • Can be used to separate different environments, for example, a test from a production environment.

B: correct because yes you need HBAs to connect to the FC. C is obviously wrong as the FS is VMFS not NFS

D is wrong because: Page 37 of the vSphere storage guide says.

– For multipathing to work properly, each LUN must present the “same” LUN ID number to all ESXi hosts.

http://pubs.vmware.com/vsphere-50/topic/com.vmware.ICbase/PDF/vsphere-esxi-vcenter- server-50-storage-guide.pdf

Question No: 127 – (Topic 3)

Where must the VMware vSphere Storage Appliance Manager (VSA Manager) be installed?

  1. On a Windows virtual machine created on the first VSA host

  2. The VSAManager is deployed as a separate virtual appliance

  3. On a vCenter Server outside of the VSA environment

  4. It is pre-installed on the VMware vSphere Storage Appliance

Answer: C Explanation:

VMware vsphere storage appliance manager is always installed on a vcenter server that resides outside of VSA environment.

Question No: 128 – (Topic 3)

Using the vSphere Storage Appliance (VSA) Manager to view the Appliances Status column, what are three valid states? (Choose three.)

  1. Degraded

  2. Connected

  3. Maintenance

  4. Online

  5. Offline

Answer: A,D,E

Reference:http://blogs.vmware.com/vsphere/2011/09/vsphere-storage-appliance-vsa- network-outage-scenario-1-back-end.html

Question No: 129 – (Topic 3)

A virtual machine requires a 4TB disk for application data. The storage administrator has already created and presented a 4TB LUN to an ESXi 5.x host. The host is currently configured with a single 500GB VMFS5 datastore.

What is the next step the vSphere administrator must use to provision the data disk?

  1. Create a virtual compatibility mode RDM mapping to the 4TB LUN.

  2. Create a physical compatibility mode RDM mapping to the 4TB LUN.

  3. Expand the existing VMFS volume to 4TB. Create a physical compatibility mode RDM mapping to the 4TB LUN.

  4. Expand the existing VMFS volume to 4TB. Create a virtual compatibility mode RDM mapping to the 4TB LUN.

Answer: B

Reference: http://sostech.wordpress.com/2011/08/12/vsphere5-storage-import-a-4tb-lun/

Question No: 130 – (Topic 3)

Which two statements are true about shared storage capabilities on NFS datastores supported by ESXi 5.x? (Choose two.)

  1. You can create Fault Tolerant virtual machines

  2. You can mount up to 256 NFS datastores

  3. You can use VMware Storage APIs with all NFS datastores

  4. You can use Storage vMotion from a virtual-mode RDM

Answer: A,B

Reference:http://www.vmware.com/pdf/vsphere5/r50/vsphere-50-configuration- maximums.pdf(page 3, see storage maximums)

100% Ensurepass Free Download!
Download Free Demo:VCP510PSE Demo PDF
100% Ensurepass Free Guaranteed!
VCP510PSE Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

Your email address will not be published. Required fields are marked *