[Free] 2018(Apr) EnsurePass Braindumps Cisco 210-065 Dumps with VCE and PDF 131-140

Ensurepass.com : Ensure you pass the IT Exams
2018 Apr Cisco Official New Released 210-065
100% Free Download! 100% Pass Guaranteed!

Implementing Cisco Video Network Devices v1.0

Question No: 131 – (Topic 5)

Which three Cisco TelePresence endpoints support hosting embedded multisite conferences? (Choose three.)

  1. EX60

  2. EX90

  3. C20

  4. C90

  5. SX10

  6. SX20

  7. Jabber Video for Cisco TelePresence

Answer: B,D,F

Question No: 132 – (Topic 5)

A network engineer wants to perform a factory reset on a Cisco TelePresence MX device from the CLI. Which command should be used?

  1. xConfiguration FactoryReset

  2. xCommand FactoryReset

  3. xCommand SystemUnit FactoryReset

  4. xConfiguration SystemUnit FactoryReset

Answer: C

Question No: 133 – (Topic 5)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

What can be deduced from the log shown in the exhibit, which was taken from a Cisco TelePresence Codec C60?

  1. A direct call to 52902511 is being made.

  2. A Multiway call to multiway221@osl147.local is being made.

  3. No calls are being attempted by the endpoint.

  4. A BFCP call is being initiated.

  5. The endpoint is receiving a call from the VCS.

Answer: B

Question No: 134 – (Topic 5)

A network administrator is asked to configure a video conference using the Cisco TelePresence MCU 5300. There is a requirement for participants to start with the same layout when joining the conference. How can this goal be accomplished?

  1. Layouts cannot be customized on the MCU 5300.

  2. Configure a custom layout for each user individually.

  3. Configure a custom layout and apply the layout to all new participants.

  4. Allow each endpoint to configure its own layout.

Answer: C

Question No: 135 – (Topic 5)

Which statement is true about the Cisco TelePresence System 500-32 system regarding the HVAC needs for the room where it is installed?

  1. The system does not require any additional requirements above the normal HVAC requirements for the room.

  2. You must supply additional cooling requirements for the room.

  3. You must supply a room that has energy-efficient lighting to reduce the temperature of the room.

  4. The temperature of the room will be 10 to 20 degrees warmer than the rest of the building.

Answer: A

Question No: 136 – (Topic 5)

An engineer needs to configure a mobile device that registers with Cisco Unified Communications Manager to utilize voice and video services. The device is Android-based. The username in Cisco Unified Communications Manager is quot;rsmith.quot; What is the proper device name for the engineer to configure?

  1. ANDRSMITH

  2. ANDSMITHR

  3. BTDRSMITH

  4. BOTRSMITH

  5. UCMRSMTH

Answer: D

Question No: 137 – (Topic 5)

Refer to the exhibit.

Ensurepass 2018 PDF and VCE

Which CLI command should be run to resolve these alarms on a Cisco VCS?

  1. xcommand DefaultValuesSet

  2. xconfiguration DefaultLinksAdd

  3. xcommand DefaultLinksAdd

  4. xconfiguration DefaultValuesSet

Answer: C

Question No: 138 – (Topic 5)

Video conference bridges accomplish their conferencing functionality by doing media transcoding or media switching. What are the three main advantages of media switching? (Choose three.)

  1. extremely low latency

  2. endpoints that can customize layouts

  3. the ability to upscale low-resolution video

  4. lower cost per port

  5. typically higher port capacity

  6. the ability for endpoints to connect at different bandwidth speeds and resolutions

Answer: A,D,E

Question No: 139 – (Topic 5)

Which three of these are functions of the Cisco TelePresence Management Suite? (Choose three.)

  1. automatic software update and release keys

  2. intelligent call routing engine

  3. provisioning a Cisco TelePresence System endpoint

  4. tracing SIP and H.323 calls

  5. managing phonebooks for endpoints that are registered to the Cisco Unified Cisco Unified Communications Manager

  6. rebooting endpoints that are registered to the Cisco TelePresence Video Communications Server

Answer: A,B,F

Question No: 140 – (Topic 5)

A customer has a data and VoIP converged network and would like to add video to this network. Which two key QoS elements should be included in the new network design? (Choose two.)

  1. Configure bandwidth management features to smooth bursty traffic and mitigate end-to- end congestion.

  2. Assign a high priority to transactional traffic to maintain quality of business traffic.

  3. Keep video traffic on the low latency queue and move voice traffic to a lower-priority

    queue.

  4. Apply bandwidth control features that will guarantee bandwidth for the maximum possible amount of video traffic.

  5. Assign both video and voice traffic to use the highest-priority queue.

Answer: A,D

100% Ensurepass Free Download!
Download Free Demo:210-065 Demo PDF
100% Ensurepass Free Guaranteed!
210-065 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

Leave a Reply

Your email address will not be published. Required fields are marked *